Sliding Window / October 23, 2018 / Marc Girard.
To install sliding window locks you need the following tools: Sliding windows can be lifted to varying degrees within their track. If you are using the venting position it is a good idea to fit something in the track to stop the window from being lifted. Small blocks of wood or plastic or just a screw can be used. If fitted correctly this can make the window a lot more secure especially when locking the window in the open position.
You will have to choose a window with an electrical socket nearby in order to connect the air conditioner unitproperly. Remove any furniture or obstacles near the window which could impede air flow. You must thoroughly check the window sill to see if it will act as a stable base for air conditioner unit. You will have to replace it if it is cracked or corrupt before you proceed with installation of the unit. Now install the metal brackets use to support the AC at a level which is set for it. These brackets need to be nailed at the center.
Remove The Windows. You can easily remove the windows by sliding it open past the lift blocks and then placing your hands on either side of the window and lifting it out of its track. You can then remove the window towards you. Do the same with the other window and place them in a safe area. Proceed With The Washing. Wash them using a window cleaning solution and a nonlint cloth. Make sure to thoroughly clean the glass and remove any stains that you will find. Start from the upper left corner of your window glass and proceed downward using an Sshaped motion for wiping the window.
Next you need to install the head rail. Just like the lower track the pivot brackets must be a few inches from the wall. Sometimes you may need more than one track to cover a room. This also allows the window panels to be stacked upon each other. If you want to add an additional valance to the mix make sure you use one that is deigned for that window panel. Otherwise it will not fit correctly.