Sliding Window / July 14, 2018 / Tearlach DuLin
Especially good for covering patio doors these window coverings preserve an outdoors look. Some interior decorators also use them as attractive room dividers. The dramatic size of these wall to wall floor to floor window coverings creates a striking image. To install these window coverings you need some kind of track to hold the window frame. Unlike wood blinds where the window and blinds are separate in sliding panels they are the same. Some have tracking on the top and bottom while some only have it on one side.
Next you need to install the head rail. Just like the lower track the pivot brackets must be a few inches from the wall. Sometimes you may need more than one track to cover a room. This also allows the window panels to be stacked upon each other. If you want to add an additional valance to the mix make sure you use one that is deigned for that window panel. Otherwise it will not fit correctly.
You will have to gently raise the unit and slide the same in support brackets. Just mark a point where the unit hits the window. Now raise the window and attach the foam strip all along the line properly. If required just attach the extensions on the side wall by using the wood screws. If necessary attach the extensions on the side wall using wood screws. Perform application blocking. Perform application blocking up o the point where air conditioner comes in contact with window. This step will ensure proper sealing and would prevent any cold air from escaping.