Sliding Window / November 8, 2018 / Christabel Gosselin.
Remove The Windows. You can easily remove the windows by sliding it open past the lift blocks and then placing your hands on either side of the window and lifting it out of its track. You can then remove the window towards you. Do the same with the other window and place them in a safe area. Proceed With The Washing. Wash them using a window cleaning solution and a nonlint cloth. Make sure to thoroughly clean the glass and remove any stains that you will find. Start from the upper left corner of your window glass and proceed downward using an Sshaped motion for wiping the window.
Next you need to install the head rail. Just like the lower track the pivot brackets must be a few inches from the wall. Sometimes you may need more than one track to cover a room. This also allows the window panels to be stacked upon each other. If you want to add an additional valance to the mix make sure you use one that is deigned for that window panel. Otherwise it will not fit correctly.
Sliding window locks are often called vent locks as they allow the window to be locked slightly open for ventilation. The recommended gap is 100mm but never have more than 150mm. The theory is that if a head can get through a window a person can squeeze through. The venting position is not as secure as when the window is shut and locked. Therefore you should only leave your windows locked open you are at home.
Casement windows are attached vertically with hinges to one side on a wall. They usually open with a crank mechanism. A single window or a pair of windows can be fitted into a frame. They open all the way outward and are wide open from top to bottom and sidetoside. A sliding window is a window that slides along a track inside the window frame. The frame may consist of many tracks depending on the number of windows on the tracks. They open horizontally and give a hundred percent view of the outside.