Sliding Window / July 14, 2018 / Tearlach DuLin
You will have to choose a window with an electrical socket nearby in order to connect the air conditioner unitproperly. Remove any furniture or obstacles near the window which could impede air flow. You must thoroughly check the window sill to see if it will act as a stable base for air conditioner unit. You will have to replace it if it is cracked or corrupt before you proceed with installation of the unit. Now install the metal brackets use to support the AC at a level which is set for it. These brackets need to be nailed at the center.
You will have to gently raise the unit and slide the same in support brackets. Just mark a point where the unit hits the window. Now raise the window and attach the foam strip all along the line properly. If required just attach the extensions on the side wall by using the wood screws. If necessary attach the extensions on the side wall using wood screws. Perform application blocking. Perform application blocking up o the point where air conditioner comes in contact with window. This step will ensure proper sealing and would prevent any cold air from escaping.
Next you need to install the head rail. Just like the lower track the pivot brackets must be a few inches from the wall. Sometimes you may need more than one track to cover a room. This also allows the window panels to be stacked upon each other. If you want to add an additional valance to the mix make sure you use one that is deigned for that window panel. Otherwise it will not fit correctly.