Awning Windows / August 4, 2018 / Tearlach DuLin
Remove The Windows. You can easily remove the windows by sliding it open past the lift blocks and then placing your hands on either side of the window and lifting it out of its track. You can then remove the window towards you. Do the same with the other window and place them in a safe area. Proceed With The Washing. Wash them using a window cleaning solution and a nonlint cloth. Make sure to thoroughly clean the glass and remove any stains that you will find. Start from the upper left corner of your window glass and proceed downward using an Sshaped motion for wiping the window.
You will have to gently raise the unit and slide the same in support brackets. Just mark a point where the unit hits the window. Now raise the window and attach the foam strip all along the line properly. If required just attach the extensions on the side wall by using the wood screws. If necessary attach the extensions on the side wall using wood screws. Perform application blocking. Perform application blocking up o the point where air conditioner comes in contact with window. This step will ensure proper sealing and would prevent any cold air from escaping.
To install sliding window locks you need the following tools: Sliding windows can be lifted to varying degrees within their track. If you are using the venting position it is a good idea to fit something in the track to stop the window from being lifted. Small blocks of wood or plastic or just a screw can be used. If fitted correctly this can make the window a lot more secure especially when locking the window in the open position.