Sliding Window / October 31, 2018 / Guillaume Roussel.
Always be sure to avoid abrasive cleaners such as cleansers and products containing bleach as they can affect the vinyl surface or the caulking around the window. Also avoid using a power washer or hard spraying hose as this too can damage the caulk. Besides occasional exterior cleaning the tracks and runners on your vinyl sliders should be checked every few weeks to make sure they are clear of debris. Vinyl sliding windows glide horizontally and open the full length of the window.
You will have to gently raise the unit and slide the same in support brackets. Just mark a point where the unit hits the window. Now raise the window and attach the foam strip all along the line properly. If required just attach the extensions on the side wall by using the wood screws. If necessary attach the extensions on the side wall using wood screws. Perform application blocking. Perform application blocking up o the point where air conditioner comes in contact with window. This step will ensure proper sealing and would prevent any cold air from escaping.
Casement windows are attached vertically with hinges to one side on a wall. They usually open with a crank mechanism. A single window or a pair of windows can be fitted into a frame. They open all the way outward and are wide open from top to bottom and sidetoside. A sliding window is a window that slides along a track inside the window frame. The frame may consist of many tracks depending on the number of windows on the tracks. They open horizontally and give a hundred percent view of the outside.
You will then need to install the panels into the rails. This can be hard because they are designed to not fall out. There may be Velcro strips you can install on the inside of the head rail to secure the windows. This should also let you slip in the panels. The valance returns attach to joiners but you may have to trip excess fabric. Woven wooden valances come with an aluminium L joint in the corner that inserts into the panel. The last step is to install the cords which move the panels along the track.